Ez Trimmer Parts List and Assembly

PARTS LIST

 

    1. Lower stand
      1. Cross bar x 2 
      2. Elbows x 4
      3. Sides x 4
    2. Upper stand
      1. Sides x 4
      2. Mounting plate with plunge pins x 2
      3. Drum knobs x 2
    3. Drum
      1. Rubber inner drum x 2
      2. Aluminum inner drum liner x 1
      3. Gate window guides with plates x 2
      4. Wet grate x1 
      5. Dry grate x 1
      6. Drum side mounts x 2
      7. Draw latch keepers x 8
      8. Link lock latches x 4
      9. Adjustment bracket buttons x 4
    4. Lid
      1. Outer lid – front x 1
      2. Outer lid – back – x 1
      3. Inner lids with knobs x 2
      4. Airflow controller x 1
      5. Draw latches x 4
      6. Spring draw latches x 2
      7. Control box with power cords x 1
      8. Lid plate x 1
    5. Motor
      1. Main motor x 1
      2. Cutting blade with hub x 1
      3. Fan blade with hub x 1
      4. Motor plate x 1
      5. Motor legs x 4
      6. Adjustment brackets x 4
      7. Adjustment knobs with bolts and collar x 4
      8. Link lock latch keepers x 4
      9. Junction box with power cord  x 1
      10. Motor cover x 1
    6. Chute
      1. Chute x 1
      2. Draw latch x 2
    7. Filtration bags
      1. Bag 1 x 1
      2. Bag 2  x 1
      3. Bag 3 x 1
      4. Bag 4 x 1

ASSEMBLY

  1. Remove plastic and cut banding to remove box from pallet
  2. Remove the chute, stand, drum with motor assembly, and filtration bags from the box
  3. Unlatch the outer lids and remove the drum knobs and maintenance kit
  4. Remove the plastic protection from both sides of the lids and fasten the draw latches
  5. If trimming wet, completely unlatch the lid and unplug the motor power cord, remove the lid, remove the dry grate, reinstall the lid and fasten
  6. Extend the lower stand out from the upper stand until the snap buttons Engauge (ensure that all four snap buttons have engaged)
  7. Insert the 2 drum knobs into the holes of the stand side plates and screw into the drum side mounts (Do not tighten! leave the drum knobs 2-3 turns loose)
  8. With assistance, grab the drum knobs and drum and lift the drum until the stand is underneath, spread the legs of the stand until fully opened
  9. Secure the drum knobs and engage the plunge pins
  10. Dial in the blade (Please reference the steps below for dialing in the blade)
  11. Disengage the plunge pins and loosen the drum knobs 2-3 turns
  12. Rotate the drum upside down and tighten the knobs
  13. Install the four filtration bags by stretching them around the bottom of the drum and above the link lock latches starting with bag #1 (the bags have number tags at the top of one of the side hems, keep the bags inside out)
  14. Loosen the drum knobs, rotate the unit back to upright, plug in the 5 pin power cord from the motor to the lid
  15. Fasten the chute to the front of the drum with the 2 draw latches
  16. Place a collection bucket or bin below the chute
  17. Plug the unit into a 120 VAC power outlet 
  18. The Ez Trimmer is ready for us